HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands
114
IOPn.Ethernetx Enable Operation
This command enables an Ethernet adapter that was disabled.
Note: For information on enabling a faulted Ethernet adapter, refer to Chapter 9.
Command IOPn.Ethernetx Enable Operation
Console Syntax MTCCONS IOPn.ETHERNETx Enable Operation
Variables
n – the ID number of the IOP (1 or 2)
x – the ID number of the Ethernet adapter
Results Check the Windows NT Event Viewer on the CE for the following message:
IOPn.MtcDsl status: Physical device Ethernet adapter on IOPn of
logical device Ethernetx on IOPn is online.
See Also IOPn.Ethernetx Disable Operation
IOPn.Ethernetx Reset Port Counters
The Ethernet Provider maintains error counters and statistics for each configured Ethernet
adapter. This command initializes the counters to zero for the specified adapter on the specified
IOP. This command has no effect on the counters maintained by the third-party Ethernet adapter
driver.
Command IOPn.Ethernetx Reset Port Counters
Console Syntax MTCCONS IOPn.ETHERNETx Reset Port Counters
Variables n – the ID number of the IOP (1 or 2)
x – the ID number of the Ethernet adapter
See Also IOPn.Ethernetx Show Port Counters