HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands
126
IOPn.EventProvider Remove Events
Warning: Use this command only at the request of your service provider.
This command removes any events from pending queues. This command should be used only
when the event queue is full and cannot be emptied due to circumstances such as the CE
operating system is unavailable.
Command IOPn.EventProvider Remove Events
Console Syntax MTCCONS IOPn.Event Remove Events
Variables
n – the ID number of the IOP (1 or 2)
IOPn.EventProvider Set Checkpoint
This command places a checkpoint event in the event log. Use this command to insert a
checkpoint in the Event Viewer for diagnostic purposes.
Command IOPn.EventProvider Set Checkpoint
Console Syntax MTCCONS IOPn.Event Set Checkpoint
Variables n – the ID number of the IOP (1 or 2)
Results Check the Windows NT Event Viewer on the CE for the following message
whose event number is 37:
IOPn.MtcEvtp status: This is a checkpoint generated from a system
management application.