HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

129
Chapter 5 Commands
IOPn.InputProvider Disable Automatic Switchover
This command prevents input devices from automatically switching over from the IOPs to the
CEs during CE boot, as described in HP NetServer AA Boot Process 17 in Chapter 2. After
issuing this command, if you want input devices to switch to the CE (during CE boot), you must
manually switch over the input devices, using either the hotkey, the IOPn.InputProvider Set
Input Devices IOP command, or the IOPn.InputProvider Set Input Devices CE command.
By default, automatic switchover for input devices is enabled.
Command IOPn.InputProvider Disable Automatic Switchover
Console Syntax MTCCONS IOPn.InputProvider Disable Automatic Switchover
Variables
n – the ID number of the IOP (1 or 2)
See Also IOPn.InputProvider Enable Automatic Switchover
IOPn.InputProvider Set Input Devices CE
IOPn.InputProvider Set Input Devices IOP
IOPn.InputProvider Show Automatic Switchover
IOPn.InputProvider Disable Hotkey
This command disables hotkeys that can be used to toggle input devices between the local IOP
and the CE for the tuple. By default, hotkeys are enabled.
Command IOPn.InputProvider Disable Hotkey
Console Syntax MTCCONS IOPn.InputProvider Disable Hotkey
Variables
n – the ID number of the IOP (1 or 2)
See Also IOPn.InputProvider Enable Hotkey
IOPn.InputProvider Show Hotkey