HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands
146
IOPn.Monitor Show Auto Start
This command displays the Auto Start setting for the specified IOP.
• If Auto Start is true (enabled), the specified IOP does not wait for the other IOP, and it
continues processing software.
• If Auto Start is false (disabled) and the other IOP is not faulted or disabled, the specified
IOP waits indefinitely to initialize with the other IOP.
By default, Auto Start is disabled.
Command IOPn.Monitor Auto Start -disable_safeguard
Console Syntax MTCCONS IOPn.Monitor Show Auto Start -disable_safeguard
Variables
n – the ID number of the IOP (1 or 2)
x – the ID number of the IOP (1 or 2)
Results For an example of the results of this command, refer to IOPn.Monitor Show
Parameters on page 152.
See Also IOPn.Monitor Disable Auto Start
IOPn.Monitor Enable Auto Start
IOPn.Monitor Show Parameters