HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

147
Chapter 5 Commands
IOPn.Monitor Show Client Status
This command displays the status of the clients listed in the ClientList Registry parameter on
the specified IOP. If no clients are specified in the client list, the following error message
displays:
An invalid parameter was provided by the caller.
Command IOPn.Monitor Show Client Status
Console Syntax MTCCONS IOPn.Monitor Show Client Status
Variables
n – the ID number of the IOP (1 or 2)
Results
Table 5-24 Monitor Client Status
Va l ue Meaning
clientId Client ID of a software component that registers with the monitor
Registration Flag True indicates that the client has registered with the monitor
Client state Client states (None, Ready, Active, Failed)
Client substate Client substates (None, Join_Init, Merge_Init, Updating)