HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

163

Chapter 5 Commands

Tuple Enable Operation

This command enables any faulted or disabled tuple component (IOP and/or CE). After the

tuple component is enabled, it can rejoin the server.

Command Tuplen Enable Operation From IOPx

Console Syntax MTCCONS Tuplen Enable Operation From IOPx

Variables n – the ID number of the Tuple (1 or 2)

x – the ID number of the IOP (1 or 2)

Results To verify that CEn and IOPn have been enabled, either:

• Check the tuple status displayed in the Endurance Manager Main

window.

• Issue a IOPn.Monitor Show Configuration command from either IOP to

make sure that the CE and IOP are no longer disabled or faulted.

• Review the Windows NT Event Viewer for a message that indicates that

the CE and IOP in the specified tuple were enabled.