HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

175
Chapter 6 Configuration Utility
Committing When a Floppy Drive is Not Available
To commit configuration changes when a floppy drive is not available (it is redirected) on either
IOP:
Step Action Notes
1On the IOP where you made the
configuration changes:
a. Select Save As, and save the file on the
IOP system disk.
b. Reboot the IOP and select Endurance
Maintenance Mode as the flex boot
option.
c. After the IOP reboots, login and copy the
file to a diskette.
d. Reboot the IOP into Operational
Endurance I/O Processor Mode and
allow any pending mirror copies to
complete.
If the IOP is operational, make sure that you follow
the appropriate shutdown procedure (page 207)
.
2On the other IOP:
a. Reboot the IOP, and select Endurance
Maintenance Mode as the flex boot
option.
b. After the IOP reboots, login and copy the
file from diskette to the IOP system disk.
c. Reboot the IOP into Operational
Endurance I/O Processor Mode.
If the IOP is operational, make sure that you follow
the appropriate shutdown procedure (page 207).
3On each IOP, use the Endurance
Configuration Utility to:
a. Open the configuration file that you
saved to the IOP system disk.
b. Select Commit.