HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 6 Configuration Utility
178
Refer to Chapter 2 in the HP NetServer AA Solution Installation Guide for more information
about installing and configuring SCSI adapters. To confirm a SCSI device address using the
Windows NT Registry on the IOP:
Table 6-3 describes the SCSI parameter mappings to the Windows NT Registry entries.
Table 6-3 SCSI Parameter Mappings in the Windows NT Registry
Step Action Notes
1 Open the Windows NT Registry.
2 Choose
HKEY_LOCAL_MACHINE\HARDWARE\
DEVICEMAP\Scsi.
3 Choose the SCSI Port for your adapter. If you are using multiple adapters, check the Driver
parameter (on the right side of the Registry window)
to make sure that you choose the correct adapter.
4 Choose \Scsi Bus x\Target ID
x\Logical Unit ID x
5 On the right side of the Registry window,
make sure that the Identifier and Type
parameters describe the SCSI device that
you want to add.
6 Map the Registry information to the SCSI
parameters that you need to provide in the
Endurance Configuration Utility, as
described in Table 6-3.
Registry Entry Maps to this Endurance Configuration Utility SCSI Parameter
SCSI Port number SCSI Adapter Number
SCSI Bus number SCSI Bus Number
Target ID
Initiator ID
Target ID. Note that the terms “Target ID” and “SCSI ID” mean the same thing.
Initiator ID. The ID used by the SCSI adapter.
Logical Unit LUN