HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 7 Tools and Utilities
190
Upgrading MIC Firmware with MTCFLASH
To upgrade the MIC firmware on each IOP and each CE:
Step Action Notes
1 Insert the MTC diskette into the computer’s
local floppy drive.
2 Reboot the computer.
3 At the MS-DOS prompt, type mtcflash
-f, and wait for the upgrade to complete.
4 Remove the diskette from the floppy drive.
5 If the CE computers do not require the
keyboard or mouse to complete POST, you
can remove them now.
6 Reboot the computer, either with the reset
button or by powering the computer off and
then on again.
7 As the computer reboots, make sure that the
MIC revision information properly reflects
the newly installed MIC firmware revisions.
MIC revision information is displayed to the
computer’s video monitor during boot. If your
server does not have a monitor attached to the CE,
either attach a monitor temporarily, or use the
monitor/keyboard/mouse switch if you installed one.
In this case, you would view the CE display in the
CE Desktop window on the IOP, via the CE Desktop
application.