HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 9 Maintenance
216
Replace an Interconnect Fiber Cable on an Offline System
Use the following procedure to replace an interconnect fiber cable on an offline system.
Caution: Before proceeding, make sure you are properly grounded using, for instance, a
wrist strap with an attached alligator clip that is connected to an appropriate
ground.
4 Enable the ESI path if it is faulted. Use Endurance Manager for this step.
5 Make the components at each end of the
ESI path online or active.
Step Action Notes
1 Shut down and power off the system. See Shutting Down the Server on page 214.
2 Disconnect the existing cable from the
system.
3 Connect the replacement cable to the
system.
4 Power on and boot the system.
5 Enable the ESI path if it is faulted. Use the Endurance Manager for this step.
6 Make the components at each end of the
ESI path online or active.
Step Action Notes