HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

221
Chapter 9 Maintenance
Installing a New MIC
Caution: Before proceeding, make sure you are properly grounded using, for instance, a
wrist strap with an attached alligator clip that is connected to an appropriate
ground.
To install a new MIC:
Step Action Notes
1 Carefully remove the new MIC from its
antistatic packaging.
2 Install the new MIC into the correct slot.
3 Replace the cover.
4 Attach the MIC fiber connections by
clipping them into the cable receptacles.
Ensure that local and remote connections are cabled
correctly. For information about cabling the MICs,
refer to Table 2-2 in Chapter 2 of HP NetServer AA
Solution Installation Guide.
5 Power up the system.
6 Record the revision information. This information is displayed on the screen while
the server is booting.
7 Compare the MIC revision information
reported during boot to the MIC revision
required for your server software (as noted
in the Release Notes). If they do not match,
run the MTCFLASH Utility, described in
Chapter 7, to install the correct MIC
firmware; otherwise, the system cannot join
the server.
Mtcflash - f results in the correct configuration.
If all flash components are up to date, MTCFLASH
does not reprogram the MIC.