HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

245
Appendix A MIC Specifications and LEDs
MIC LEDs
Each MIC has LEDs which indicate the status of the firmware and of the local and remote fiber
connections. Figure A-1 is a representation of the MIC LEDs.
Figure A-1 MIC LEDs
Table A-3. describes the firmware LED.
Table A-4. describes the fiber LEDs.
Table A-3.
Firmware LED
State Indicates
Off No power, or MIC is not working.
Rapid Red Flash (5-10 seconds)
Rate of 1/10th second
MIC is running the self-test which occurs after reset.
Solid Red MIC has failed to initialize or pass the self-test.
Flashing Red\
Rate of 1 second
MIC is alive and waiting for connections.
Flashing Green MIC is alive, and connections are active.
Table A-4. Fiber LEDs
State Indicates
No light No power, or no fiber signal is detected.
Green The MIC hardware is transmitting and receiving fiber status through the
fiber connector.
ware status
Firm
Local connection fiber status
Remote connection fiber status