HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 4 Endurance Manager

Redirected

Devices

Indicates the status of the redirected devices that are defined in the server configuration

(Chapter 6). The redirected device types are described below.

The icon for a redirected device type is displayed only if one or more devices of that type

are redirected. For example, the serial port icon is displayed only if a serial port is

redirected.

Note: If the IOP where the redirected device physically resides is powered off, faulted,

or not booted in Operational EnduranceI/O Processor Mode, the status of the

redirected devices may be reported as unknown.

If more than one mirrored disk set or non-mirrored disk is present in the system, it is

represented as a stack of disks. To determine a disk’s position in the stack, start at the

bottom of the stack and count disks, starting with zero, as you move up the stack. Because

the non-mirrored disks appear only in the disk stack on the IOP where they reside, the

position of a mirror set member on one IOP may be in a different location relative to the

location of its mirror set member on the other IOP.

For information on how to configure redirected devices, refer to Chapter 6.

Device states are documented in Chapter 2.

SCSI Disks Indicates the status of the redirected SCSI disks

from that IOP. The SCSI disk icon displays the

number of redirected SCSI disks. For example, the

icon shown on the left indicates that four SCSI

disks are redirected from this IOP to the CE.

CD-ROMs

Tape Devices

Serial Ports

Indicates the status of the redirected device from

this IOP. The icon for these devices reports their

status on a 1:N basis. For example, if more than

one CD-ROM is redirected from an IOP, the least

desirable state of any CD-ROM is shown using the

icon.

Table 4-2 Administration Window Contents (Continued)

Component Description