HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

59
Chapter 4 Endurance Manager
Table 4-6 Last Mirror Copy Status Window Contents
Option Description
Disk Identifies the SCSI disks associated with a mirror set (for example, Disk0).
Note: Endurance disk names, such as Disk0 and Disk1, do not necessarily match the
names of Windows NT similarly named disks, as seen when viewed with Disk
Administrator.
Status Contains one of the following:
Done Mirror copy completed successfully.
Failed Mirror copy did not complete.
Note: A mirror copy may not complete for a variety of
reasons, such as an IOP may have been taken
down, a disk may have failed or been disabled, or
a disk may have encountered a bad spot.
Pending Mirror copy is waiting to start.
Note: A mirror copy target disk is offline while a
mirror copy is pending. It transitions to online
as the mirror copy begins.
Started Mirror copy is in progress.
Unable A disk was located, but it cannot participate in a mirror
copy. For example, it may be faulted or it may have
been explicitly disabled.
Unknown State of the disk cannot be determined. For example, if
an IOP or one or more members of a mirror set are not
found, it is not possible to determine whether a mirror
copy is needed.
Current Mirrored disks contain identical information; no copy is
required.
IOP1
IOP2
Identifies the direction of a mirror copy by:
S Indicates which IOP is the source of the mirror copy.
D Indicates which IOP is the destination of the mirror
copy.
% Indicates the percentage of data that has been copied.