HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

75
Chapter 5 Commands
Verifying Commands
After issuing a command, you can verify that it executed successfully by completing at least one
of the following.
• Use the Endurance Manager to make sure that the status of the server component matches
the state that you expected.
• Use the Endurance Manager to issue an IOPn.Monitor Show Configuration command
(page 148) from either IOP to make sure that the component reflects the appropriate state.
• Verify that the expected output is displayed in the command output window.
• If you issued a reset command, you can execute the corresponding show command to
verify that the command was executed as expected.
• Use the Windows NT Event Viewer to check for a message describing that the operation
was completed “by operator request.”