HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands

CE Disable Auto Boot

This command disables Auto Boot for a specific CE. Auto Boot allows the CE to automatically

boot the CE’s Windows NT operating system after a reboot or power cycle. If you disable Auto

Boot, the operating system cannot be booted on this CE until you issue a CE Enable Auto Boot

command. If you are setting this option to prevent a CE from joining the server configuration,

make sure that you disable both Auto Boot and Auto Synch (page 81) on that CE. Otherwise,

in certain scenarios, the CEs can boot and synchronize.

By default, Auto Boot is true (enabled).

Command CEn Disable Auto Boot From IOPx

Console Syntax MTCCONS CEn Disable Auto Boot From IOPx

Variables n – the ID number of the CE (1 or 2)

x – the ID number of the IOP (1 or 2)

Results To verify that Auto Boot is disabled for CEn, issue a CEn Show Auto Boot

or CEn Show Parameters command from either IOP.