HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands

CE Disable Auto Synch

This command disables Auto Synch for a specific CE. Auto Synch allows the second CE to

automatically attempt to synchronize with the running CE. If you disable Auto Synch, you

cannot synchronize that CE into the server until you issue a CE Enable Auto Synch command.

If you are setting this option to prevent a CE from joining the server configuration, make sure

that you disable both Auto Boot (page 80) and Auto Synch on that CE.

By default, Auto Synch is true (enabled).

Command CEn Disable Auto Synch From IOPx

Console Syntax MTCCONS CEn Disable Auto Synch From IOPx

Variables

n – the ID number of the CE (1 or 2)

x – the ID number of the IOP (1 or 2)

Results To verify that Auto Synch is disabled for CEn, issue a CEn Show Auto Synch

or CEn Show Parameters command from either IOP.