HP NetServer AA 6200 Solution Release 3.0 Messages

Chapter 13 MtcMon Messages
186
IOPn.MtcMon status: IOPx is faulted and requires repair. page 261
IOPn.MtcMon status: IOPx is OFFLINE because the /NOMTC switch is present in BOOT.INI. page 261
IOPn.MtcMon status: IOPx is unavailable for initialization. page 262
IOPn.MtcMon status: IOPx is unavailable for initialization because it is currently DISABLED. page 262
IOPn.MtcMon status: IOPx is unavailable for initialization because it is currently FAULTED. page 263
IOPn.MtcMon status: IOPx joining has been aborted because the thresholding database was modified.
IOP initialization and joining will be retried.
page 263
IOPn.MtcMon status: IOPx was removed at the direction of IOPy. page 264
IOPn.MtcMon status: IOPx was removed because it failed to activate the CE Interconnect(s). page 265
IOPn.MtcMon status: IOPx was removed from service to allow the CE operating system to be booted. page 266
IOPn.MtcMon status: Monitor initialization failed on the local IOP. page 266
IOPn.MtcMon status: No ECC or parity memory detected on CEx. Chipset: vendor chipset. Memory
mode: mode. IPMI found: Y/N
page 267
IOPn.MtcMon status: Removing CEx so crash dump can proceed with only one active CE. page 267
IOPn.MtcMon status: Server shutdown has been requested by the operator. page 268
IOPn.MtcMon status: The active CEs were removed because the boot device is no longer accessible. page 269
IOPn.MtcMon status: The boot conflict could not be resolved. page 269
IOPn.MtcMon status: The boot process has completed for CEx. page 270
IOPn.MtcMon status: The boot process has failed for CEx. page 270
IOPn.MtcMon status: The boot process has failed for CEx because the 16-bit platform initialization
did not complete successfully.
page 271
IOPn.MtcMon status: The boot process has started for CEx. page 271
IOPn.MtcMon status: The CE BIOS base addresses are not compatible. CE1 BIOS base address =
0xx. CE2 BIOS base address = 0xy.
page 272
IOPn.MtcMon status: The CE CPUx feature sets do not match. CE1 CPU ID register set = 0xy. CE2
CPU ID register set = 0xz.
page 273
IOPn.MtcMon status: The CE CPUx feature sets do not match. CE1 CPU ID register set = 0xy. CE2
CPU ID register set = 0xz.
page 273
Table 13-1 IOPn.MtcMon Messages (Continued)
Message Page