HP NetServer AA 6200 Solution Release 3.0 Messages

Chapter 1 Introduction
14
Table 1-5HP NetServer AA Message Summary – Prefixed Messages
Message Page
IOPn.MtcDgs status: Datagram Service protocol version mismatch. page 91
IOPn.MtcDgs status: Error accessing data in the Registry. page 91
IOPn.MtcDgs status: Error in NIC bindings. page 91
IOPn.MtcDgs status: Error transferring incoming Ethernet packet to the receive buffer. page 92
IOPn.MtcDgs status: Ethernet transmit error. page 92
IOPn.MtcDgs status: Incomplete transfer of incoming Ethernet packet to the receive buffer. page 92
IOPn.MtcDgs status: Initialization error page 92
IOPn.MtcDgs status: Invalid Ethernet packet received. page 93
IOPn.MtcDgs status: Invalid Registry parameter. Using default value. page 93
IOPn.MtcDgs status: NIC receive data lookahead buffer is too small. page 93
IOPn.MtcDgs status: Receive packet allocation failure. page 93
IOPn.MtcDgs status: Send packet allocation failure. page 94
IOPn.MtcDgs status: Unable to open NIC. page 94
IOPn.MtcDgs status: Unable to query or set NIC. page 94
IOPn.MtcDsl status: A packet with an invalid transport command was received
(offendingValue).
page 98
IOPn.MtcDsl status: A provider has an invalid Registry entry (provName). page 98
IOPn.MtcDsl status: A provider has attempted to register more than once (provName). page 98
IOPn.MtcDsl status: A request contained an invalid provider ID (offendingValue). page 99
IOPn.MtcDsl status: A request for provider provName used an invalid logical device ID. page 99
IOPn.MtcDsl status: A request for provider provName used an invalid physical device ID. page 100
IOPn.MtcDsl status: A tack timeout condition was not cleared properly. page 100
IOPn.MtcDsl status: A tacked flush packet has an unknown flush type (offendingValue). page 100
IOPn.MtcDsl status: An invalid client callback ID was encountered (offendingValue). page 101
IOPn.MtcDsl status: An invalid component state was encountered (offendingValue). page 101