HP NetServer AA 6200 Solution Release 3.0 Messages

15
Chapter 1 Introduction
IOPn.MtcDsl status: An invalid component type was encountered (offendingValue). page 101
IOPn.MtcDsl status: An invalid DSL packet ID was encountered (offendingValue). page 102
IOPn.MtcDsl status: An invalid IOP state was encountered (offendingValue). page 102
IOPn.MtcDsl status: An invalid logical device operation type was encountered
(offendingValue).
page 103
IOPn.MtcDsl status: An invalid packet descriptor was encountered. page 103
IOPn.MtcDsl status: An invalid reset reason code was encountered (offendingValue). page 103
IOPn.MtcDsl status: An invalid resync flush state was encountered (offendingValue). page 104
IOPn.MtcDsl status: An invalid subprovider ID was encountered (offendingValue). page 104
IOPn.MtcDsl status: An invalid transaction ID was encountered (offendingValue). page 104
IOPn.MtcDsl status: Invalid device entries in the IOP’s configuration were pruned. This
indicates an improperly set up device configuration. This problem may have occurred due to
hand modifications of the Windows NT Registry. The problem may be fixed by re-running
the HP NetServer AA Configuration Utility.
page 105
IOPn.MtcDsl status: Physical device phyDevName of logical device logDevName on IOPx
is offline.
page 105
IOPn.MtcDsl status: Physical device phyDevName of logical device logDevName on IOPx
is online.
page 106
IOPn.MtcDsl status: Provider provName experienced an internal failure. page 106
IOPn.MtcDsl status: The IOPs could not be joined because IOP 1 has a different device
configuration than IOP 2. This problem may be fixed by comparing the configurations and
making them consistent.
page 106
IOPn.MtcDsl status: Unable to allocate a callback descriptor. page 107
IOPn.MtcDsl status: Unable to allocate a callback worker thread. page 107
IOPn.MtcDsl status: Unable to find a flush descriptor on the global flush list. page 107
IOPn.MtcDsl status: Unable to initialize the DSL. page 108
IOPn.MtcDsl status: Unable to run provider’s callback routine provName. page 108
IOPn.MtcDsl status: Unable to start a full flush due to an internal software error. page 108
IOPn.MtcEthP status: A call to NdisRequest timed out. page 115
Table 1-5HP NetServer AA Message Summary – Prefixed Messages (Continued)
Message Page