HP NetServer AA 6200 Solution Release 3.0 Messages

Chapter 13 MtcMon Messages
244
IOPn.MtcMon status: CEx has been enabled by operator request.
Va r ia b le s x – the ID of the CE that has been enabled
Severity Informational
Description The specified CE has been enabled using a CE Enable or Tuple Enable command. The CE had
previously been in a faulted or disabled state and is now available for configuration into the
Endurance server.
Related Messages
IOPn.MtcMon status: CEx is faulted and requires repair.
IOPn.MtcMon status: CEx has been disabled by operator request.
IOPn.MtcMon status: Tuplex has been disabled by operator request.
Hardware/Software This message is generated as a result of issuing a software command.
Action No action is required.
IOPn.MtcMon status: CEx has been removed from service.
Va r ia b le s x – the ID of the CE that has been removed
Severity Informational
Description The specified CE has been removed from the Endurance server. The removal may occur as a
result of either:
• A system failure requiring the removal of the CE
• An Endurance Manager command
• A normal shutdown of the Windows NT operating system on the CE
Related Messages
IOPn.MtcMon status: CEx has been disabled by operator request.
IOPn.MtcMon status: CEx is faulted and requires repair.
IOPn.MtcMon status: The Windows NT operating system on the active CE(s)
has been shut down by operator request.
IOPn.MtcMon status: The Tuplex shutdown or disable completed
successfully.
Hardware/Software This message is generated as a result of a hardware or software failure or issuing a command
to shut down the CE’s operating system.
Action • If the CE was removed as a result of a command, no action is necessary.
• If the CE was removed as a result of a fault, examine the event logs to determine the
source of the failure.
• Then repair the fault and reboot the CE.