HP NetServer AA 6200 Solution Release 3.0 Messages

329
Chapter 14 MtcScsiP and MtcScsiR Messages
IOPn.MtcScsiP status: DISKn is not partitioned. Use Disk Administrator in Offline HP NetServer AA I/O Processor
Mode to partition the disk, making sure to add an HP NetServer AA partition.
Va r ia b le s n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description All disks used in an HP NetServer AA configuration must be partitioned. The disk specified
in the message was not partitioned.
Action Repartition the disk. See Chapter 9 in HP NetServer AA Solution Administrator’s Guide for
details about repartitioning a mirrored disk.
IOPn.MtcScsiP status: DISKn may not be SCSI-2 (or newer SCSI standard) compliant.
Va r ia b le s n – the disk number; for example, DISK0, DISK1, DISK2
Severity Warning
Description DISKn may not be SCSI-2 (or newer SCSI standard) compliant. Some SCSI devices and some
RAID controllers do not indicate SCSI-2 compliance. In these cases, HP NetServer AA
software cannot determine SCSI-2 compliance.
Action No action is required. However, if the device immediately experiences unexpected errors after
it is installed, then the potential lack of SCSI-2 compliance may be the cause of these errors.
In this case, contact your service provider for assistance.
IOPn.MtcScsiP status: DISKn member in the other IOP is remapping bad blocks encountered during mirror copy.
Mirror copy timeout was ignored.
Va r ia b le s n – the disk number; for example, DISK0, DISK1, DISK2
Severity Informational
Description The administrator has used the HP NetServer AA Manager to enable the disk's mirror set peer
to remap any bad blocks encountered during a mirror set copy.
Action No action is required.