HP NetServer AA 6200 Solution Release 3.0 Messages

Chapter 1 Introduction
32
IOPn.MtcScsiP status: DEVICEn has a SCSI logical unit number (LUN) different than
configured on the other IOP, and it will be marked offline.
page 312
IOPn.MtcScsiP status: DEVICEn has a target ID different than configured on the other IOP,
and it will be marked offline.
page 312
IOPn.MtcScsiP status: DEVICEn location contains an unsupported device. page 312
IOPn.MtcScsiP status: DEVICEn location does not contain the expected device type. page 313
IOPn.MtcScsiP status: DEVICEn powered up successfully. page 313
IOPn.MtcScsiP status: DEVICEn was not found, and it will be marked offline. page 313
IOPn.MtcScsiP status: Disk could not be enabled. page 313
IOPn.MtcScsiP status: Disk is a mirror copy target. Status is offline pending copy start. page 314
IOPn.MtcScsiP status: Disk is already disabled. page 314
IOPn.MtcScsiP status: Disk is already online. page 314
IOPn.MtcScsiP status: Disk must be offline. page 314
IOPn.MtcScsiP status: DISKn cannot be accessed for initialization, and it will be marked
offline.
page 315
IOPn.MtcScsiP status: DISKn cannot be physically accessed. See prior events for reason. page 315
IOPn.MtcScsiP status: DISKn contains an invalid partition table. The disk must be
repartitioned.
page 315
IOPn.MtcScsiP status: DISKn contains too few partitions. Use Disk Administrator in
Offline HP NetServer AA I/O Processor Mode to partition the disk, making sure to add an
HP NetServer AA partition.
page 316
IOPn.MtcScsiP status: DISKn copy target on IOPx has been newly installed, but copy
source on IOPy has not. Install CE and IOP software on copy source (IOPy).
page 316
IOPn.MtcScsiP status: DISKn could not be enabled. Check prior events for reason. page 316
IOPn.MtcScsiP status: DISKn did not come ready, and it will be marked offline. page 317
IOPn.MtcScsiP status: DISKn did not power up properly, and it will be marked offline. page 317
IOPn.MtcScsiP status: DISKn does not have a bootable partition. Use Disk Administrator in
Offline HP NetServer AA I/O Processor Mode to mark the desired boot partition as active.
The disk will be kept offline until it contains a partition marked as bootable.
page 318
Table 1-5HP NetServer AA Message Summary – Prefixed Messages (Continued)
Message Page