HP NetServer AA 6200 Solution Release Notes (Release 3.0 Service Pack 1)

HP NetServer AA Solution Release Notes
18
It is very important that you use the correct version of MTCFLASH to update the MICs.
You may need to use a different version of MTCFLASH than that on the MTC diskette
you created from the HP NetServer AA Solution CD, according to the instructions in
Chapter 7 of the HP NetServer AA Solution Administrator’s Guide. Therefore, replace
Step 10 on page 18 with the following:
• In the HP NetServer AA Solution Installation Guide, there is an error in Chapter 2,
Hardware. Two steps in the section Installing the Adapters in the CEs should be deleted.
Delete Steps 12 and 13 from page 21.
• In the HP NetServer AA Solution Installation Guide on page 31, the table describing
“Windows NT Installation Guidelines for the HP NetServer AA Solution CE” contains the
following statement which includes an error:
HP NetServer AA Solution CEs must run multiprocessor Windows NT software even
if the CE is a uniprocessor computer.
Do not interpret this statement to mean that uniprocessor CEs are permitted in an HP
NetServer AA Solution Release 3.0 or 3.0 Service Pack 1 server. Multiprocessor CEs are
required in Release 3.0 and 3.0 Service Pack 1. Otherwise, the server will not boot.
• In the HP NetServer AA Solution Installation Guide, there is an error in Step 6 on page 52.
The Note in Step 6 should state: Select only the IOP software option.
• In the HP NetServer AA Solution Installation Guide on page 58, in the section Completing
Step Action Notes
10 Insert the MTC diskette in the floppy drive,
and restart the IOP.
Warning: Make sure that the version of
MTCFLASH you use coincides with
your hotfix level. If you have a hotfix
that supersedes what is contained on the
MTC diskette you created, use the hotfix
diskette to flash the MICs. In that case,
do not use the MTC diskette you created
from the
HP NetServer AA
Solution
CD.