HP Netserver AA Solution Administrator's Guide v4.0 SP1

5-14 HP Netserver AA Solution Administrator’s Guide

CE Enable Operation

This command enables a faulted or disabled CE, allowing it to join the active Endurance server.

Command CEn Enable Operation From IOPx

Console Syntax MTCCONS CEn Enable Operation From IOPx

Variables n – the ID number of the CE (1 or 2)

x – the ID number of the IOP (1 or 2)

Results To verify that CEn has been enabled, either:

• Issue an IOPx Show Configuration command from either IOP to make

sure that the CE and any associated components (such as CEn.MIC) are

not disabled.

• Check the Windows Event Viewer for a message stating that the CE was

enabled by operator request.

See Also CE Disable Operation

CE Remove From Configuration

This command removes CEn from the configuration, resets it, and reboots it. When the CE

reboots, it tries to rejoin the Endurance server. If you do not want the CE to rejoin the Endurance

server, power it off or use the CE Disable Operation command.

Warning: If only one CE is in operation, use a Windows Shutdown

command instead. This command does not perform a normal

Windows shutdown. As a result, you can lose any data in the

disk cache that has not been written to the disk.

Command CEn Remove From Configuration From IOPx

Console Syntax MTCCONS CEn Remove From Configuration From IOPx

-disable_safeguard

Note: The -disable_safeguard argument is needed only for the last CE

online.

Variables n – the ID number of the CE (1 or 2)

x – the ID number of the IOP (1 or 2)