HP Netserver AA Solution Administrator's Guide v4.0 SP1

Commands 5-15

Results Check the Windows Event Viewer for a message that indicates that the CE

has been shut down, disabled, or removed from service.

See Also CE Disable Auto Boot

CE Disable Auto Synch

CE Disable Operation

CE Enable Operation

CE Show Auto Boot

This command shows the state of the Auto Boot parameter for a specific CE. Auto Boot allows

the CE to automatically boot the CE’s Windows operating system after a reboot or power cycle.

By default, Auto Boot is true (enabled).

Command CEn Show Auto Boot From IOPx

Console Syntax MTCCONS CEn Show Auto Boot From IOPx

Variables n – the ID number of the CE (1 or 2)

x – the ID number of the IOP (1 or 2)

Results The value for Auto Boot is displayed as either: true (enabled) or false

(disabled). For an example of the results of this command, refer to CE Show

Parameters (5-16).