HP Netserver AA Solution Administrator's Guide v4.0 SP1

5-16 HP Netserver AA Solution Administrator’s Guide

CE Show Auto Synch

This command shows the state of the Auto Synch parameter for a specific CE. Auto Synch

allows the CE to automatically synchronize with the other CE after a reboot. If you disable Auto

Synch, you cannot synchronize that CE until you issue a CE Enable Auto Synch command. By

default, Auto Synch is true (enabled).

Command CEn Show Auto Synch From IOPx

Console Syntax MTCCONS CEn Show Auto Synch From IOPx

Variables

n – the ID number of the CE (1 or 2)

x – the ID number of the IOP (1 or 2)

Results The value for Auto Synch is displayed as either: true (enabled) or false

(disabled). For an example of the results of this command, refer to CE Show

Parameters (5-16).