HP Netserver AA Solution Administrator's Guide v4.0 SP1

Commands 5-35
IOPn.Ethernetx Commands
The IOPn.Ethernetx commands perform operations on Ethernet adapters. step Table 5-12 lists
the IOPn.Ethernetx commands.
IOPn.Ethernetx Disable Operation
This command disables an Ethernet adapter. After you disable an Ethernet adapter, the adapter
remains disabled until you issue an IOPn.Ethernet Enable Operation command. Disabling the
active adapter causes failover to the standby adapter on the other IOP.
Warning: Do not issue this command unless the other IOP’s Ethernet
adapter is in standby mode. If the other IOP’s Ethernet adapter
is not in standby mode and you issue this command, the
Endurance server loses network connectivity.
Command IOPn.Ethernetx Disable Operation
Console Syntax MTCCONS IOPn.ETHERNETx Disable Operation
Variables
n – the ID number of the IOP (1 or 2)
x – the ID number of the Ethernet adapter
Results Check the Windows Event Viewer on the CE for the following message:
IOPn.MtcDsl status: Physical device Ethernet adapter on IOPn of
logical device Ethernetx on IOPn set to disabled.
See Also IOPn.Ethernetx Enable Operation
Table 5-12 IOPn.Ethernetx Commands
Command Page
IOPn.Ethernetx Disable Operation 5-35
IOPn.Ethernetx Enable Operation 5-36
IOPn.Ethernetx Reset Port Counters 5-36
IOPn.Ethernetx Show Port Counters 5-37
IOPn.Ethernetx Show Port Information 5-39