HP Netserver AA Solution Administrator's Guide v4.0 SP1

Commands 5-51

Variables n – the ID number of the IOP (1 or 2)

x – the timeout value that you want to set. The timeout range is 0 to 300

seconds. If the timeout is 0, arbitration is disabled (default), and input is

accepted from both IOPs.

See Also IOPn.InputProvider Show Arbitration Timeout

IOPn.InputProvider Set Hotkey Value

This command defines the hotkey sequence that toggles input devices between the IOP and the

CEs. By default,

<Ctrl><Shift>F12 is the hotkey sequence.

Command IOPn.InputProvider Set Hotkey Value x

Console Syntax MTCCONS IOPn.InputProvider Set Hotkey Value x

Variables

n – the ID number of the IOP (1 or 2)

x – the hotkey value that you want to define. Hotkeys are a minimum of two

values. The hotkey must contain at least one value from Column A and

one value from Column B:

The default hotkey is

<Ctrl><Shift>F12.