HP Netserver AA Solution Administrator's Guide v4.0 SP1

5-74 HP Netserver AA Solution Administrator’s Guide
IOPn.ScsiProvider Commands
The IOPn.ScsiProvider commands display information about the SCSI Provider. Table 5-32
lists the IOPn.ScsiProvider commands.
IOPn.ScsiProvider Set Mirror Copy Bias
This command sets a bias (preference) favoring either CE disk throughput or mirror copy
completion time. This setting is only relevant when a mirror copy is in progress. By default, the
bias is two.
Command IOPn.ScsiProvider Set Mirror Copy Bias
Console Syntax MTCCONS IOPn.ScsiProvider Set Mirror Copy Bias
Variables n – the ID number of the IOP (1 or 2)
x – a value between 0 and 4, where 0 sets a preference for CE disk throughput,
and 4 sets a preference for mirror copy completion time. By default, the
bias is 2.
Results The setting of the bias value has an immediate effect. For example, if a mirror
copy is in progress and you change this setting from 2 to 4, the mirror copy
has an increased preference over CE disk throughput. The setting remains in
effect, even after IOPs are rebooted.
See Also IOPn.ScsiProvider Show Mirror Copy Bias
Table 5-32 IOPn.ScsiProvider Commands
Command Page
IOPn.ScsiProvider Set Mirror Copy Bias 5-74
IOPn.ScsiProvider Show Bad Block Status 5-75
IOPn.ScsiProvider Show Mirror Copy Bias 5-76
IOPn.ScsiProvider Show Mirror Status 5-77