HP Netserver AA Solution Administrator's Guide v4.0 SP1

9-18 HP Netserver AA Solution Administrator’s Guide
Replacing an IOP
To replace an IOP, complete the following procedures:
• Removing an IOP
• Preparing a New IOP for Installation
• Installing a New IOP
Removing an IOP
Caution: Before proceeding, make sure you are properly grounded using,
for instance, a wrist strap with an attached alligator clip that is
connected to an appropriate ground.
To remove an IOP from the Endurance server configuration:
Step Action Notes
1 Shut down the IOP that you want to
replace.
Use the Shutting Down an IOP
procedure on
page 9-5.
2 Label and then detach the following
cables from the IOP:
• The power cord from the IOP.
• The MIC fiber cables by squeezing
the connectors to unclip them and
then detaching them.
• The Ethernet cable that connects the
IOP to the public Ethernet network.
• The IL cable from the IOP.
• The video cable, the keyboard, and
the mouse.
3 If the IOP is rackmounted, remove it
from the rack.