HP Netserver AA Solution Administrator's Guide v4.0 SP1

9-20 HP Netserver AA Solution Administrator’s Guide
Installing a New IOP
Caution: Before proceeding, make sure you are properly grounded using,
for instance, a wrist strap with an attached alligator clip that is
connected to an appropriate ground
.
After preparing the new IOP, finish installing the new IOP:
Note: For detailed instructions, refer to the HP Netserver AA Solution Installation
Guide.
Step Action Notes
1 If required, fasten the rackmount
brackets and install the IOP in the rack.
2 Attach the following cables to the IOP:
• The power cord.
• The MIC cable.
• The Ethernet cable that connects the
IOP to the public Ethernet network.
• The IL cable.
• The video cable, the keyboard, and
the mouse.
3 Plug in the power cord.
4 Power up the new IOP.
5 If you installed the IOP boot disk from
the IOP that you replaced, continue with
Step 6.
Otherwise, install Windows and Endurance
software as described in Chapter 3 of the HP
Netserver AA Solution Installation Guide. This
includes:
• Installing the Windows operating system.
• Installing Endurance software only for this IOP.
• Using the Endurance Configuration Utility to
make any appropriate changes to the
configuration. If the configuration has changes,
you must update the configuration on both
IOPs. Refer to Chapter 6 for information.