HP Netserver AA Solution Administrator's Guide v4.0 SP1

5-4 HP Netserver AA Solution Administrator’s Guide
Verifying Endurance Commands
After issuing an Endurance command, you can verify that it executed successfully by
completing one of the following.
• Use the Endurance Manager to make sure that the status of the Endurance server
component matches the state that you expected.
• Use the Endurance Manager to issue an IOPn.Monitor Show Configuration command
(5-69) from either IOP to make sure that the component reflects the appropriate state.
• Verify that the expected output is displayed in the command output window.
• If you issued a reset command, you can execute the corresponding show command to
verify that the command was executed as expected.
• Use the Windows Event Viewer to check for a message describing that the operation was
completed by operator request.