HP Netserver AA Solution Installation Guide v4.0 SP1

3-2 HP Netserver AA Solution Installation Guide
Overview of Endurance Installation
To complete an Endurance installation, you will follow this basic procedure:
IOPs
CE
Install Windows on IOP1.
(page 3-4)
Complete the post
installation tasks.
(page 3-19)
Install Endurance software
on IOP1. (page 3-8)
Configure the network
software. (page 3-10)
Use the Endurance
Configuration Utility to
configure redirected
devices on IOP1.
(page 3-16)
Install Windows on IOP2.
(page 3-22)
Install Endurance software
on IOP2. (page 3-8)
Configure the network
software. (page 3-10)
Configure the devices on
IOP2 using the .cfg file
created on IOP1.
(page 3-16)
Complete the post
installation tasks.
(page 3-19)
Partition the CE disks.
(page 3-19)
Run MtcPrep to prepare for
the Unattended Installation.
(page 3-23)
Allow the Unattended
Installation of Windows and
the Endurance software to
complete. (page 3-25)
Complete the Endurance
installation on the active
CE. (page 3-28)
Join IOP1 and IOP2.
(page 3-22)
Install the appropriate
Service Pack.
(page 3-28)
Configure the network
software. (page 3-29)
Adjust the Event Log
settings. (page 3-31)
Partition and format the CE
disks. (page 3-19)
Verify the Endurance
installation. (page 3-31)