HP Netserver AA Solution Installation Guide v4.0 SP1

3-26 HP Netserver AA Solution Installation Guide
Completing the Unattended Installation
The procedure you follow to complete the Unattended Installation of the CE software is
dependent upon your specific hardware configuration.
For a KVM Switch
If your configuration contains a keyboard, video, mouse (KVM) switch with a port for each CE
and IOP, follow these steps to complete the Unattended Installation of the CE software:
Step Action Notes
1 Use the KVM switch in order to view the CE1 video. Select the port connected to CE1’s
keyboard, video, and mouse.
2 The Windows screen Configure Your Server should
be displayed.
This occurs at the conclusion of step 11
of the previous section, up to one hour
after the start of the CE installation.
Viewing this screen indicates that Setup
has completed on the CE.
3 Use the KVM switch to change focus to the IOP in
order to view the IOP’s video.
Select the port connected to IOP1’s
keyboard, video, and mouse.
4
From the application task bar, select Start
Programs Marathon Endurance
Endurance Manager to start the Endurance
Manager.
5 Using the Endurance Manager, invoke the
command CE_O/S Shutdown Operation from
IOPx, where x is the ID number of the IOP from
which you issue the command.
The CE Endurance System
Management service initiates the
system shutdown.
6 On the IOP, start the CE Desktop application. For information about the CE Desktop
application, refer to Chapter 3 of the HP
Netserver AA Solution Administrator’s
Guide.
Once the CE has rebooted, the video,
keyboard, and mouse are redirected to
the IOP.