HP Netserver AA Solution Installation Guide v4.0 SP1

Installing Windows and the Endurance Software 3-27
For a Monitor Attached Directly to the CE
If your configuration contains a monitor attached directly to the CE, follow these steps to
complete the Unattended Installation of the CE software:
Continue with Completing Software Installation on the CEs.
Step Action Notes
1 View the CE video on the CE monitor.
2 The Windows screen Configure Your Server should
be displayed.
This occurs at the conclusion of step 11
of the previous section, up to one hour
after the start of the CE installation.
Viewing this screen indicates that Setup
has completed on the CE.
3 While viewing the IOP’s video, from the application
task bar, select Start Programs Marathon
Endurance Endurance Manager to start the
Endurance Manager.
4 Using the Endurance Manager, invoke the
command CE_O/S Shutdown Operation from
IOPx, where x is the ID number of the IOP from
which you issue the command.
The CE Endurance System
Management service initiates the
system shutdown.
5 On the IOP, start the CE Desktop application. For information about the CE Desktop
application, refer to Chapter 3 of the HP
Netserver AA Solution Administrator’s
Guide.
Once the CE has rebooted, the video,
keyboard, and mouse are redirected to
the IOP.