HP Netserver AA Solution Administrator's Guide v4.0 SP1

5-22 HP Netserver AA Solution Administrator’s Guide

Results To verify that IOPn has been disabled, either:

• Check the Windows Event Viewer for a message that indicates that IOP

has been shut down, disabled, or removed from service.

• Issue an IOP Show Configuration command on the CE. Then verify that

IOPn is disabled and any associated components (such as IOPn.MIC) are

offline.

See Also IOP Enable Operation

IOP Shutdown Operation

IOPn.Monitor Show Configuration

IOP Enable Operation

This command enables the specified IOP that was disabled or faulted. The IOP attempts to

rejoin the Endurance server immediately or when it reboots the Windows operating system.

Command IOPn Enable Operation From IOPx

Console Syntax MTCCONS IOPn Enable Operation From IOPx

Variables

n – the ID number of the IOP (1 or 2) you want to enable

x – the ID number of the IOP (1 or 2) that issues the enable command

Results To verify that IOPn has been enabled, either:

• Issue an IOP Show Configuration command from either IOP.

• Check the Windows Event Viewer on the CE (or on the IOP that you

enabled) for a message that indicates that the IOP is enabled.