Hewlett-Packard Network Server Division HP NetServer E 60 Frequently Asked Questions
HP NetServer E 60 Frequently Asked Questions Q1. Which Processors are supported in the NetServer E 60 A1. The NetServer E 60 supports Intel Pentium II 400 MHz, P II 450 MHz, P III 500 MHz and PIII 550 MHz processors. Q2. What is new on the front panel of the NetServer E 60? A2.
Q6. What is the maximum number of internal disk drives support in the NetServer E 60? A6. The self-terminating SCSI cable has five 68-pin high-density connectors. The internal mass storage cage can hold up to four Ultra Wide SCSI hard disk drive devices. In some models T20Xi tape is installed in the lowest 5 ΒΌ front accessible shelf. One 68-pin connector connects to the factory installed hard disk and one 68-pin connector with 68 to 50 pin adapter connects to an optional tape drive.
Q10. Describe the internal mass storage configuration options? A10.
Q13. What optional SCSI kits are available for the NetServer E 60? A13. HP NetServer E 60 SCSI Duplexing Cable kit P/N D8212A/D9153A Use to mirror drives internally on two different SCSI channels in case one channel goes down. This requires a minimum of two hard disk drives and the Duplexing Cable Kit. D9153A cable kit can be used with NetRAID 1Si or for duplexing.
Q17. What is the PCI slot initialization order? A17. During system boot, the PCI slots are initialized in the following order: PCI slot 2 PCI slot 1 PCI slot 6 PCI slot 3 PCI slot 4 PCI slot 5 Please note that ONLY two bootable plug in SCSI controllers or NetRAID 1Si/NetRAID 3Si are supported. Q18. Which Disk Array Controller (NetRAID) card supported in the NetServer E 60? Q18. HP recommends ONLY using the NetRAID 3Si (D5595A) and NetRAID 1Si (D2140A) PCI board in the NetServer E 60.
