HP Netserver E 60 Quick Service Guide

7
System Switch Details
On
Off
Off = KBD power on
Unused
On = Clear Password
On = Clear Configuration
1
2
3
4 5 6 7 8
400 Mhz
450 Mhz
500 Mhz
The switches and each of their definitions are listed below.
Switch
position
Factory
preset Definition:
1 OFF Off - let's you power on your system by pressing any key on the keyboard or the power-
on button.
On – let's you power on the system only by pressing the power-on button.
2 Unused
3 OFF
Clears the password. Set the switch to the ON position and restart the NetServer to
clear the password. Return the switch to the OFF position and restart the NetServer to
return to normal operation.
4 OFF Resets the CMOS configuration to the default values. Set the switch to the ON position
and restart the NetServer to reset the CMOS. Return the switch to the OFF position and
restart the NetServer to return to normal operation.
5 - 8
(See table
below)
Select processor speed settings. The switch positions may need to be changed when
upgrading the processor (see table below).
Processor Switch Settings
The following table shows the settings for each Intel processor module. To set the switches correctly, observe the
markings on the replacement processor module. Each processor module will have a speed marking. Use the table
below to look up the appropriate switch settings for each of these CPUs.
CPU Speed
Switch 5 Switch 6 Switch 7 Switch 8
400 MHz OFF OFF ON OFF
450 MHz ON OFF ON OFF
500 MHz OFF ON ON OFF