HP Support Anywhere Installation and User Guide
Chapter 3 Installing the HP Support Anywhere Software
29
◊ Network and SNMP Info
∗ IP and IPX Addresses (as appropriate)
A Windows NT server can be assigned either an IP address (such
as 15.60.89.90), or an IPX address.
A NetWare server is usually assigned an IPX address
(A1234567.123456789123), but may also have an IP address. Type
in the IP and/or IPX address(es) for each selected server.
NOTE Web servers cannot function without an IP address. You must
designate the IP address for NetWare web servers.
∗ SNMP Community
You need to tell Support Anywhere the NetServer's SNMP
Community name. This is "public" by default, but if your server is
identified using a different community name, type that name in the
SNMP Community field.
After filling out the Selected Server Info fields for each NetServer, click
Save Server Info. Setup saves the configuration information about the
selected server. Go on to configure the next server on your Server List. Be
sure to save configuration information for each server as you continue
through the Server List.
In an exclusive Novell NetWare environment, all HP NetServers must
include web server software for web interface management. If this
describes your network, client setup is complete. Proceed to Part 2:
Setup at Each NetServer.
6. Configure your web servers.
In an environment that includes Windows NT servers, remember that
Windows NT web servers can support non-web servers, both NetWare and
Windows NT.
A. Start by selecting a web server from the servers you specified as
Windows NT web servers earlier in the setup process.
B. Click to select a web server in this list box.
C. Select all non-web servers that the selected web server will support.
Remember, to utilize Support Anywhere's web management feature
for your non-web servers, you must add them to the support list of
a Windows NT web server. To select a non-web server in this list,
click to highlight it. You may select more than one.