HP Netserver E 800 Installation Guide

Setting Up the HP NetServer E 800
7
3. Connect the cables (data & power).
4. Replace the drive cage.
Slots for Tabs
Captive
Screws (3)
First insert screws through
round holes in back
(one on each side).
Tabs(2)
CAUTION All mounting screws used to thread into the hard disk drive
must be #6-32 and not exceed ¼-inch in length. Longer
screws may cause internal damage to the mass storage device.
Damage caused by incorrect mounting screws is not covered
by the HP warranty.