Installing MS BackOffice Small Business Server 4.x

18
31. Enter 10 digit CD Key. (Read your SBS 4.5 CD-ROM label to obtain the 10 digit CD
key.)
32. Click <Next> at the installed modems screen.
33. Click <Yes> at the fax server dialog box to accept that the service will not be
installed.
34. Hardware Confirmation screen shows the following:
One IDE CD-ROM (ATAPI 1.2)
One AHA-294x…
One Video 800x600…
No NIC. (The NIC needs to be added next)
35. Click <Change>.
36. The control panel folder is now opened. Double click <Network>.
37. Click <Adapters> tab.
38. If present, remove loopback adapter.
39. Click <Add>.
40. Click <Have a Disk>.
41. Insert the Hewlett Packard "NT 4.0 Drivers diskette". Type the following path
a:\nicdrv and Click <OK>
42. Click <OK> to accept the default selection "HP 10/100 TX PCI Adapter".
Note: The default protocol parameters are:
IP address = 10.0.0.2
Subnet mask = 255.0.0.0.
Primary and Secondary Wins = 10.0.0.2
You may change these parameters now if needed. HP recommends you complete the
installation with the defaults and change them later.
43. Click <Close>.at the Add adapter panel.
44. Click <OK> at the RAS is not configured with any ports.
45. Click <Yes>. To restart system now.
46. If present, Click <OK> at the "Service control manager" dialog box.
47. The system comes up with the setup wizard. Click <Next>. At the modem install
panel.