Installing MS BackOffice Small Business Server 4.x

24. Setup continues to copy more files to your hard disk. Remove any diskette from the

drive.

25. SBS will display a message "Restarting the computer" at the bottom of the display.

26. The system will resume the NT Setup process. It will do a check disk, convert from

FAT to NTFS and reboot. (You may see a support pack 3 message on the display

when booting at this time.)

27. Enter user name, company.

Update Computer name, domain name if needed.

28. Click <Next> to continue.

29. Click <Next> at the Installing Windows Networking option.

30. Click <OK> at the Warning that reads “A setup parameter specified…”.

31. Click <OK> at the Setup Message that reads "Remote access is not configured "

32. Click <Cancel> at the Error message that reads "The network failed to start

(0x0000042a)". This will enable us to continue the installation and configure

networking later on.

33. Configure the appropriate time zone. The system will auto-reboot.

NOTE: If installing on a NetServer E 800. Follow these steps:

Click <OK> at the error message that reads “The drivers were not successfully

pre-installed….”

Click <Cancel> at the Display Properties screen to close it and continue with the

setup.

If click <OK> at the Display Properties screen the following error message pops

up “an error occurred while Windows was working with the Control Panel file

C:\winnt.sbs\system32\disk.cpl”. Now click <OK> on the Control Panel screen.

Next click <OK> on the next screen. Then click <Cancel> to close the Display

Properties screen and continue with the setup.

34. If present. Click <OK> at the "Control Manager Screen" warning that reads "At least

one service or driver failed during system startup ....".

35. Click <OK> if you get an error about creating Domain list.

36. Click <Next> at the Welcome to SBS 4.5 Setup Wizard to accept upgrade to Service

Pack 4.