HP NetServer Common Tray Ultra3 Hard Disk Drive Installation Guide

Chapter 1 Prepare Drive for Installation
2
CAUTION In a few cases, drives with the same product number can be of
different types and require different jumper settings. If your
drive does not match the type in the figure, check the other
figures for the matching type.
Step 1: Prepare for Installation
Gather the tools and the setup information you need to install the drive, before
removing the drive from its packaging.
Tools You Need
To install the disk drive, you need the following tools:
•
Tweezers, needle-nose pliers or a similar tool for setting configuration
jumpers.
•
A Torx
TM
T-15 screwdriver or a regular blade screwdriver.
Setup Information You Need
Before you begin, you need the following setup information:
•
The HP NetServer Installation Road Map for your system or Information
Assistant on the HP NetServer Navigator CD-ROM.
•
The SCSI addresses available in your system. (Refer to your system in
Information Assistant on the HP NetServer Navigator CD-ROM for
information on determining available SCSI addresses.)