HP Netserver E 45/E 50 Remote Administrator Guide

Chapter 2 Installing HP Remote Console Redirection
13
Ending the Remote Console Session
To end a remote console session and return to normal HP NetServer
operation, press the space bar at the "HP Modem Initialization Utility"
screen displayed at the HP NetServer.
NOTE Once the NetServer's modem has been initialized, your HP
NetServer awaits a call from the remote console and is
functionally disabled until a connection is made, or until you
disable the remote login by pressing the space bar at the
server.
Setup at the Remote Console
You can use pcANYWHERE32 (shipped with each HP NetServer). Or, you may
use any standard communications program to establish a simple, character-based
terminal connection from a console workstation to the HP NetServer.
The advantage of using pcANYWHERE32 is that it is pre-configured for HP
Remote Console via the pre-install disk.
If you plan to manage your HP NetServer using either a direct terminal
connection or via modem, and you have chosen not to use Symantec's
pcANYWHERE32, make sure your terminal emulation software:
• Provides remote dial-in and communications features
• Is correctly configured for console redirection
Regardless of which communications software you use, the following parameters
apply at the server's COM port:
Table 2-2. Communications Parameters
Parameter
Required
Baud Rate 19.2K or 38.4K
Data Bits 8
Stop Bits 1
Parity None
Handshaking XON/XOFF
Connect Assert DCD
Disconnect Drop DTR