HP Netserver E 45/E 50 Remote Administrator Guide

Chapter 2 Installing HP Remote Console Redirection

Using HP Remote Console

Originating a remote management session between an HP NetServer and a

remote console involves initialization at the server (to put the server in standby

mode) and an initiating call from the remote console. Because Symantec's

pcANYWHERE32 communications software is included with your customer's HP

NetServer, the following instructions assume use of this software product at the

remote console.

At the HP NetServer

Have someone at the site with the NetServer initialize the server's modem (see

Modem Initialization above). When you initiate the Modem Initialization Utility

and select "Yes" to allow a remote login, server function is suspended until a

remote user successfully logs on. The server remains in this standby state

indefinitely until a connection is made, or until you disable the remote login by

pressing the space bar at the server.

At the Remote Console

To initiate a remote management session using pcANYWHERE32:

1. Run pcANYWHERE32 from the pcANYWHERE32 program group in

your Windows Program Manager.

2. Double-click the icon you created for your HP NetServer.

3. Enter the password you defined in the HP NetServer's modem

initialization program.

After the NetServer accepts the password, you have access to both the BIOS setup

routine and to the HP NetServer's Utility Partition.