HP Netserver E 45/E 50 Remote Administrator Guide

Chapter 3 Installing Graphic Console Redirection
20
pcANYWHERE32 allows you to redirect what's graphically displayed on an HP
NetServer running Windows NT 3.51 or 4.0 to a remote Windows NT 3.51, 4.0,
or Windows 95 PC console.
Installation of pcANYWHERE32 is a two-part process. Separate setup steps are
required for installation at the NetServer and at the workstation designated as the
remote console.
Minimum Server Requirements
In order to use Graphic Console Redirection, your server needs:
• An external modem or direct connection via one of the HP NetServer's
two serial ports
• pcANYWHERE32 communications software running on the HP
NetServer E 45 or E 50 with Windows NT Server 3.51, 4.0, or BackOffice
Small Business Server 4.0
On the HP NetServer, pcANYWHERE32 host software is optionally installed as
part of the automated installation process when the HP NetServer Navigator CD
is used to set up the system and install the Network Operating System.
Minimum Console Requirements
For the remote console, you can use any ANSI X3.64 compatible terminal or
terminal emulator with a modem or RS-232 connection. For best results, use an
ANSI color terminal that supports 25-line mode and IBM PC character set. In
addition, you will need:
• A 486-based (or faster) computer with 12 MB of available disk space.
• A communications link to the server, either through a modem or a direct
serial connection.
• pcANYWHERE32 console software. You can make master diskettes of
pcANYWHERE32 software from the HP NetServer Navigator CD-ROM
that comes with each HP NetServer system.
• Microsoft Windows 95, or Windows NT Workstation 3.51 or 4.0.