HP Netserver E 45/E 50 Remote Administrator Guide

Chapter 3 Installing Graphic Console Redirection
23
3. Click "Settings..." and then "Advanced...".
Configure using the following address and IRQ settings:
Table 3-1. HP NetServer E 45 and E 50 Default Serial Port Interrupts
Label
Port Interrupt
Serial A COM 1 3F8h IRQ 4
Serial B COM 2 2F8h IRQ 3
For best performance, check the FIFO Enabled box.
Be sure to select the same COM port you identified when you configured the
NetServer during BIOS setup. Check by booting DOS and, when prompted
during boot-up, press [F2] to run the Setup program.
NOTE You must reinitialize the modem to enable Remote Console
Redirection.
On the BIOS Setup Main Menu, cursor to the Configuration menu and select
"Integrated I/O Ports." Check the display of Integrated I/O Ports.
After you have finished running the Smart Setup Wizard, the pcANYWHERE32
main program window appears.
pcANYWHERE32
menu bar
pcANYWHERE32
action button bar
To finish configuration, at the main program window:
1. Click "Be A Host PC."
2. Select the Modem connection item (see the following figure).