HP Netserver E 45/E 50 Remote Administrator Guide

Chapter 4 Installing RCONSOLE (NetWare)

Minimum Server Requirements

In order to use RCONSOLE, your server needs:

• An external modem or direct connection via one of the HP NetServer's

two serial ports

• An HP NetServer E 45 or E 50 running Novell NetWare/IntranetWare

(3.12 or 4.11), IntranetWare for Small Business 1.10, and including

RCONSOLE software and utilities

Minimum Console Requirements

For best results, use an ANSI color terminal that supports 25-line mode and IBM

PC character set. In addition, you will need:

• A 386-based (or faster) computer with 6 MB of available disk space

• A communications link to the server, either through a modem or a direct

serial connection

• Novell NetWare's RCONSOLE program

• MSDOS 3.0 or later

Setup at the NetWare NetServer

Enabling a NetWare RCONSOLE connection at your NetServer involves several

steps, including modifying the AUTOEXEC. NCF file and rebooting the server

in order to activate the changes.

To enable a NetWare RCONSOLE connection:

1. Run the NetWare server program and at the server prompt, type:

load install

2. At the NetServer installation utility, select "NCF files options," then

"Edit AUTOEXEC.NCF file".

3. Edit AUTOEXEC.NCF, by typing the following commands, each on a

separate line:

load remote <password> [Enter}

load aio {Enter}

load aiocomx{Enter}

load rs232 <com port> 19200{Enter}