HP Netserver E 45/E 50 Remote Administrator Guide

Chapter 4 Installing RCONSOLE (NetWare)

4. Save and exit the edit by pressing [F10], then quit the install program.

5. Take the server off line. Type:

down

6. Quit the NOS. Exit the NetWare environment and enter DOS, type:

exit

7. Reboot, then run NetWare. Change to the NetWare server directory

and type:

server

At this point, your server is permanently enabled for RCONSOLE connection.

Setup at the NetWare Client

RCONSOLE software must also be installed and configured at the workstation

used as the remote console.

To install RCONSOLE software at the NetWare client workstation:

1. Copy the following files stored on the NetWare/IntranetWare CD to a

common directory:

rconsole.exe rconsole.hep rconsole.msg

textutil.hep textutil. idx textutil.msg

_run.ovl ibm_aio.ovl ibm_run.ovl

_aio.ovl

2. Switch to the directory that holds the files you just copied to the

console and run:

rconsole.exe

NOTE Novell recommends that the program rconsole.exe be run in

DOS (not in a DOS window inside Windows).

3. Select Asynchronous, then "Configuration."

Enter the settings appropriate to the modem installed at the console.

Enter any sequence of characters (limit 8) for User Connection ID.

You must make an entry for "Call-back number" even if you do not

intend to use this feature.